X-431 EURO TAB II User Manual
98
1. Power the Scopebox on: Power is provided to the Scopebox in either of the
following ways:
• Power adaptor: Insert one end of the power adaptor into the Power
interface of the Scopebox, and the other end to the AC outlet.
• Battery clamps cable: Plug one end of the power adaptor into the Power
interface of the Scopebox, and then clamp the other two terminals to the
vehicle's battery (Red to +, and Black to -) respectively.
2. Connect the B-shaped terminal of the data cable to the data I/O port of the
Scopebox, and the other end to the data I/O port of the diagnostic tool.
A. While testing sensors or actuators,
3. Connect the BNC connector of the BNC to 4mm test lead to the
CH1/CH2/CH3/CH4, and plug the black (GND) and red (SIGNAL) 4mm
connectors into the Black (GND) and other color (SIGNAL) banana sockets of
the 6-way breakout leads respectively.
Fig. 12-3
4. Connect the black terminal and signal wire (its other end connected to the red
4mm connector) of the 6-way breakout lead to the GND and signal terminal of
the vehicle sensor.
B. While testing Secondary-distributor ignition analysis/Secondary-simultaneous
(c) Launch & Diagtools. Tel. +37167704152, +37129416069. www.diagtools.lv
To Next Page
Loading...
