Need help?Do you have a question about the LCR Elite2 and is the answer not in the manual?
General| Type | LCR Meter |
|---|---|
| Basic Accuracy | 0.1% |
| Test Frequencies | 100 Hz, 120 Hz, 1 kHz, 10 kHz |
| Measurement Parameters | L, C, R, Z, D, Q, θ |
| Connectivity | USB |
LCR Research's product warranty terms and conditions for defects in materials and workmanship.
Exclusions and limitations of the product warranty, covering wear, damage, and misuse.
Defines the buyer's sole and exclusive remedies for product defects or failures.
General safety precautions for meter operation, service, and repair, emphasizing user qualification.
Precautions to avoid minor injury to yourself or damage to the product or other property.
Warnings to be followed carefully to avoid personal injury or death or damage to the product.
Introduces the LCR Elite2 as a portable impedance measuring device for quality control.
Describes the physical features and user interface components of the LCR Elite2.
Instructions on how to power on the LCR Elite2 meter using the navigation button.
Explains automatic and manual methods for powering off the meter.
How to navigate between the measurement display and the menu screens.
Details on how to charge the internal lithium-ion polymer battery via USB.
Explains the battery icon and low battery warnings displayed on the meter.
Describes the names and functions of various indicators on the meter display.
Instructions for performing a hardware reset to restore factory original settings.
Procedures for cleaning the meter and its test tips to maintain accuracy.
Provides a flowchart illustrating the menu structure and navigation paths of the device.
Explains how to navigate through the meter's menus using the navigation button.
Details the options available in the main menu: Autoset, System, Measurement, Turn Off, Exit.
Describes how the Autoset function resets measurement and test parameters to default.
Lists and describes the options within the System menu: Right Hand, Left Hand, Self CALI., Info, Exit.
Explains the process of performing short and open calibration for better accuracy.
Provides device information such as hardware (HW) and software (SW) versions.
Outlines options for selecting measurement types: LCR, SEC. PARAM., Test FREQU., CIRC. Mode.
Details settings for LCR measurement modes: Auto, Resistance (R), Inductance (L), Capacitance (C).
Explains how to select secondary parameters like Series/Parallel Resistance (Rs-Rp) or Dissipation/Quality Factor (D-Q).
Describes how to set the test signal frequency (Auto, 100Hz, 120Hz, 1kHz, 10kHz).
Explains how to set the circuit mode (Auto, Series, Parallel) for measurements.
Covers auto mode, resistance, inductance, and capacitance measurements with display overview.
Explains how the meter automatically identifies component types based on phase angle.
Details how to set up and perform resistance measurements using the LCR Elite2.
Details how to set up and perform inductance measurements using the LCR Elite2.
Details how to set up and perform capacitance measurements using the LCR Elite2.
How to choose secondary parameters like Series/Parallel Resistance or Dissipation/Quality Factor.
How to set the test signal frequency for measurements, including auto and manual modes.
How to select the circuit mode (Auto, Series, Parallel) for measurement analysis.
Lists the physical and operational characteristics of the LCR Elite2 meter.
Details compliance with safety standards (FCC, EN) and electromagnetic compatibility.
Specifies the recommended calibration cycle for the LCR Elite2 meter.
Details the specifications of the testing signal, including frequency and level.
Lists measurement ranges and optimal frequencies for Resistance, Capacitance, and Inductance.
Specifies the over voltage protection limits and conditions for the meter.
Outlines the assumptions made for the meter's accuracy specifications, including temperature and calibration.
To Next Page
