Once the selection has been made, press the "OK" control to confirm navigation,
pressing the "BACK" button, the selection will be cleared. If you did not select any zone, and
press "OK", and the equipment / system will perform an automatic selection of all zones.
In each zone depicted on screen, it is indicated the state of the zone. It will be identified
as follows:
(a) ZONE IN STATE OF EMERGENCY
Red box on the left side of the zone button. In Picture 4, zone 1
(b) SELECTED ZONE
Selection band in the right side. In Picture 4, zones 1, 2, 3, 4 and 7
(c) ZONE INDICATING FAULT
Yellow rectangle on the left side of the zone button. In Picture 4 zone 4
(d) ZONA NO SELECCIONADA
No selection band. In Picture 4, zones 5 and 6. Zone 8 can not be selected by default once
disarmed (see 3.4).
(e) DISARMED ZONE
Disabled zone. Yellow band on the right side. The button will be a dark-colored area in Picture
4 zone 8
6
www.lda-audiotech.com
To Next Page
Loading...