3.3 FAILURE
3.3.1 FAILURE STATE LOG
The system has a log of detected failures. This log will be automatically displayed on
the screen when the equipment / system is in this state for five minutes since the last entry
occurred in the log. A whole year's log will be accessible through the configuration
application .
Once the log has been checked, press the " ACK " button and the log will stop displaying
automatically. You can view it again by pressing the shortcut button to the fault state " FLT ", a
list will show in chronological order from newest to oldest, the operations and indications that
have occurred. To exit the emergency state log , press the "BACK" button.
To view all logs, use the scroll control to scroll up and down the window. You can see an
overview of all logs in Appendix B: Content of logs.
3.3.1 RESET FAILURE'S STATE
To reset the failure's state, press the " RESET" button, the display will show an user
control access level 2 (see 2.3). To return, press the " BACK" button. If you successfully
complete the control access, all faults will be reset.
3.4 DESARMING
The equipment / system provides features to disarm or disable voice alarm zones that
will not be used. Once disabled, these will be displayed in the menus, as described in section
2.2.7 (e). It is not possible to perform any operation on a disabled zone. The information
provided for the states of emergency or failure will not be displayed .
3.4.1 DEACTIVATING/ ACTIVATING A ZONE
To access the deactivation menu, press the shortcut button "DIS". From the disabling
menu press the " DISARMED STATE" option, the display will show an access control for level
2 users (see2.2.7). To return, press the " BACK" button. If you successfully complete the
access control, all zones will be displayed, make the selection or deselection of the zones to
disable/enable, and click " OK" to confirm.
When the deactivation occurs in a zone, the corresponding amplifier channels to that
zone indicate the disarmed state in the led indicators. (see 2.1.2).
3.4.2 DISARM LOG
The system has a log of disarmed zones, that displays the the operations that have
been made during the last hour in the disarmed stated. A whole year's log will be accessible
through the configuration application .
In order to view the log, press the button" DIS", and then “DISARMED LOG”. A list will
chronologically show the operations and indications that have been made. To exit the disarmed
log, press the button “BACK”.
To view all the log, use the scroll up and down button to move around the window. A
description of all the logs will be available at Appendix B.
3.5 PA MODE
The equipment / system NEO, besides acting as a voice evacuation system, can
function as a high-performance public address system, when a voice evacuation is not
required.
To access the Paging menu, proceed as follows:
LDA Audio Tech - Severo Ochoa Nº 31- 29590 MÁLAGA, ESPAÑA. Tlf: +34 952028805
21
To Next Page
Loading...