SAFETY INSTRUCTIONS
Please read carefully these safety instructions.
1. Keep this User Manual for future reference.
2. Power connectors must stay accessible for disconnection and power cord must be placed
where people will not step or stumble. Unplug the equipment from the AC/DC before
cleaning.
3. The equipment must not be exposed to water and water containers must not be placed
over it. Do not use liquid or sprayed detergent for cleaning. Do not expose this equipment
to humid areas.
4. Do not place naked flames near the equipment.
5. Install this equipment in a safe surface. If the equipment is not in a safe surface, it may fall
and be damaged.
6. The openings on the enclosure are for air convection. Do not allow overheat. DO NOT
COVER THE OPENINGS. Leave at least 5cm of space at the sides for its correct
ventilation.
7. Never open the equipment. For safety reasons, the equipment should only be opened by
qualified personnel.
8. The equipment must be plugged into a grounded outlet.
9. Pay attention to connection polarity when operating the machine with a power supply (DC).
Reverse connection polarity may cause damage to the equipment, or to the power supply.
10. Let staff check the equipment if any of these situations occur:
a) The power cord or power plug is damaged.
b) Liquid has penetrated inside the equipment.
c) The equipment has been exposed to moisture.
d) The equipment does not work well or does not work according to the instruction
manual.
e) The equipment was dropped and damaged.
f) If the equipment has obvious signs of damage.
11. Cabling must be done only by trained personnel. Disconnect the audio inputs and outputs
while making connections or disconnect the equipment from the power supply. Be sure to
use the proper cables to make the connections.
To Next Page
Loading...