Operator's Manual
l Time and Amplitude - Specifies the output file include both time and amplitude data for each
sample.
l With Header - Specifies to include a header with scaling information.
5. If you selected ASCII file format, also touch the Delimiter control and select a delimiter character from
the pop-up menu. Choose from comma, space, semicolon, or tab delimiters.
6. Touch Save Now!
AUTOSAVE
The Auto Save feature automatically saves a waveform to disk after each new trigger.
Enable Auto Save from the Save Waveform dialog by selecting one of the Auto Save buttons: Wrap (old
files overwritten) or Fill (no files overwritten).
Choosing Off diables AutoSave.
Touch the Browse button next to the Save file in directory control and navigate to the location where you
want the file saved. The file name is assigned automatically and is shown under the control.
Recall Waveform
Access the Recall Waveform dialog by either choosing File → Recall Waveform from the menu bar or
clicking the Recall Waveform button on the main Save/Recall dialog.
NOTE: Only .trc files saved in binary format can be recalled into the oscilloscope.
RECALL WAVEFORM FROM MEMORY
1. Touch Memory.
2. Touch Source and choose a memory location from the Select Source pop-up.
3. Touch Destination and select a location into which to open the recalled memory.
4. Mark Show on Recallto display the trace on the grid.
5. Touch Recall Now!
RECALL WAVEFORM FROM FILE
1. Select File.
2. Touch Recall files from directory and enter the path to the waveform folder, or touch Browse and navi-
gate to the folder.
3. Use the Up /Down Arrows to cycle through the available files until the desired file is selected.
Optionally, touch Show only files to apply a search filter (channels, math functions, or memory) to the
list of available files.
4. Mark Show on Recallto display the trace on the grid.
5. Touch Recall Now!
922499 Rev B
113
To Next Page
Loading...
Need help?
General
