Leibinger JET2 neo - Page 38

Page 36 Transport/Start up Group 5
Release R1.07 en JET2 neo
Figure 7
Print head installation (Example)
1 – Product
4 – Sensor
6 – Umbilical (Hose connection)
2 – Conveyor belt
5 – Print head
7 – Print head adapter
3 – Encoder
(accessories)
The print head should be attached vibration-free. The hose
connection of the print head should not be smaller as a radius of R60
statistically and dynamically not below R100!
The distance of the print head to the product depends on the required character
height. As smaller the required character height, as smaller the distance of the print
head to the product (smaller distances produce better type quality)
Note: In general a distance of round about 8-10 mm is recommended.
1
3
5
4
2
= Conveying direction
6
7