Leica GR10 - Logging Session Wizard: Create a New Logging Session; Edit a Logging Session

Operational Manual (Online Help)
188
Create new Logging session - Logging session wizard
Logging session wizard: Create a new logging session / Edit a logging session
Setting Descriptions
The table below describes the settings that can be configured on the Create/Edit a logging session page.
Setting
Description
Session name
Enter a unique logging session name.
• Maximum number of characters allowed is 20.
• Only certain ASCII characters are allowed.
0123456789
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
• No spaces/blanks are allowed, however underscore (_) can be used.
• The session name is used in the folder structure when storing log files.
Data type
Select the data type that shall be written.
• MDB
• RINEX
• Compact RINEX (Hatanaka)
Session priority
Select the priority level to be used for Smart clean-up of the SD card, either high,
medium or low.
If Smart clean-up is activated then the session priority will determine which logging
sessions are stopped / saved if the SD card is nearing full capacity.
Read the topic GNSS management: Smart clean-up
, for further information on the
Smart clean-up functionality .
Session type
Select the session type, either continuous or timed.
• Timed: Allows specific times to be configured for the session to log data,
including duration, repetition interval and the number of intervals.
Selecting timed will open an additional wizard step, Session timing.
Do not change a logging session created by Leica GNSS
Spider into a timed logging session. Spider cannot
configure timed logging sessions.
• Continuous: Select to define the data type file length only.
If a continuous session type is activated, it will start logging immediately.
To stop logging, manually deactivate the session via the GNSS
management: Logging sessions menu option.
Press
to continue to the next wizard step.