Leica GR10 - Setup in a Non-DHCP Network

5: Getting started
69
Setup in a non-DHCP Network
Setup in a non-DHCP network
If the instrument is setup in a non-DHCP network, the web interface can still be accessed using a crossed Ethernet cable.
Step
Description
1
Start the computer.
2
Connect the crossed Ethernet cable to the computer and the Ethernet port on the back of the
GR10/GR25/GM10.
3
Turn on the GR10/GR25/GM10.
4
On the computer go Start / Control Panel / Network Connections.
5
Select the Network connection used with the crossed Ethernet cable, right click and select Properties.
6
In the General tab, highlight Internet Protocol and press Properties.
7
Select Use the following IP address and enter,
• IP address: 192.168.0.1
• Subnet mask: 255.255.255.0