65
5: Getting started
Operation: Overview
Network technology and protocol overview
An explanation of some of the networking technologies and protocols
which are used by the receiver.
A step-by-step overview of the required equipment and cables to set
up the receiver.
• Basic setup
• Setup via Web interface over Ethernet and DHCP
• Setup in a non - DHCP network
• Install USB drivers
• Setup via Web interface over USB
Working with the Memory Device
Important safety directions for using the SD card and a step-by-step
guide on how to insert and remove an SD card.
• Use DHCP to automatically assign a hostname and all network parameters to a GR/GM Series receiver
• Use DynDNS to assign a hostname to a GR/GM Series with a static IP
• Access the web interface for the first time and change the default user
• Activate Leica support access step-by-step
• Configure coordinates and site name step-by-step
• Configure tracking settings step-by-step
• Configure a RINEX logging session step-by-step
• Configure a data stream step-by-step
A detailed description of every Web interface page is included in the Context sensitive help section.
To Next Page
