EN
173
Film presets, contrast, sharpness, color saturation:
All options described on pages 146 but in this case only the white
balance, contrast, saturation, and sharpness settings are changed.
Stabilization
► In the main menu, select
► Select the required setting in
Note:
When using video stabilization, the trimming is slightly reduced
compared to operation without stabilization.
Starting/ending the recording
In the default setting, the function button serves as video release.
If, on the other hand, one of the other optional functions is
assigned to this button, two possible procedures are available: To
utilize the function button as video release, it must be reset
accordingly.
► In the main menu, select
► In , select
If you prefer not to change the existing function button setting, you
can utilize the shutter button as an alternative after calling up the
video screen with gesture control.
Starting:
► Press the function/shutter button
• A video recording in progress is indicated by a flashing red
dot. The remaining recording time is also displayed.
Ending:
► Press the function/shutter button again
Sound recording
Sound is recorded in stereo with the built-in microphones.
To reduce any noise caused by wind during sound recording, a
damping function is available:
► In the main menu, select
► Select the required setting in
Note:
Both autofocus and changing the focal length on zoom lenses
produce noises that may be picked up in the recording.
To prevent this, you should not use either of these functions while
recording is in progress - only adjust the focus manually and do not
change the focal length.
Picture mode
To Next Page
Loading...
