xiii
DISCOVERY manual
D-H002.0607EN
• Contact your nearest Lely service provider if you have any questions.
• Hold a regular (annual) safety review with all persons who work with the equipment.
INSTALLATION SAFETY
• Read and observe the instructions in the manual. By choosing the correct place to install the appliance in your
cowshed, and mounting it securely, you will reduce the risk of mechanical errors.
• Before connecting the power, take steps to ensure that the power supplied is sufficient and has the correct
voltage, phase and frequency (see also the details on the rating plate).
• Have an authorised electrician provide electrical power to the barn cleaner.
• Ensure that the earthing of the electrical system conforms to local regulations or standards that may be in
force.
MAINTENANCE SAFETY
• Study all the information in the manual about operation, maintenance and adjustment of the barn cleaner;
make sure you understand these fully.
• SWITCH the machine OFF and completely disconnect the power supply before doing any servicing,
maintenance, adjustment, repairs or cleaning.
• Once you have completed your servicing, ensure that all safety features are back in place, working and
properly secured.
• Make certain that the power supply is SHUT OFF before you work with any electrical parts of the appliance.
Electrical circuits can cause bodily injury.
SAFETY AND ELECTRICITY
• Have an authorised electrician provide electrical power to the barn cleaner.
• Ensure that the earthing of the electrical system conforms to local regulations or standards that may be in
force.
• Make sure that all electrical switches are in the OFF position before you turn the electrical power back on.
• SWITCH the appliance OFF and completely cut off the power supply before doing any servicing,
maintenance, adjustment, repairs or cleaning.
• Replace any damaged electrical wiring, conduits, switches or other components immediately.
• Do NOT open the electrical panel to work on the electrical system, unless the electrical power is completely
disconnected at the master panel.
To Next Page
Loading...
