System operation
Chapter 4 - page 4
4
D-H002.0607EN
4.3.2 "Routes" menu
The "Routes" menu consists of the following submenus:
"Routes > Old route" menu item
Select "Old route" submenu:
• Using the UP and DOWN buttons (+ and -), scroll around the list of routes (route 1, 2, etc.). Use the button
to go the screen where the variables for the chosen action can be selected. You can use Soft2 to select the
variables and adjust the height using the UP/DOWN buttons (+ and -).
• The Soft1 button can be used to clear the action concerned.
Use the button to go back to the "Routes" menu. You are then asked whether or not the change should be
saved. The UP/DOWN selection buttons (+ and -) can be used to respond "Yes/No". Then use the and
buttons to go back to the "Routes" menu.
"Routes > New route" menu item
Before programming a route, it is important that you already have the route partially set out in your mind. Think a
couple of steps ahead when you are programming. Pick the best route for the barn cleaner. Specific points to
consider are:
Figure 4 4 "Routes" flow diagram
To Next Page
Loading...
