LELY DISCOVERY 90 S User Manual (English)

Questions and Answers:

S
Scott SmithSep 7, 2025
What to do if LELY DISCOVERY 90 S Discovery says battery power too low to start route?
- R
  rayshannonSep 7, 2025
  If the LELY Vacuum Cleaner Discovery's battery power is too low to start a route, it may be due to bad contact with the battery charger caused by dirt or corrosion, loose connections, or the battery level being too low before starting. To fix this, clean the charging strips and electrodes, manually drive the Discovery to the charging station, and ensure the battery is charging. If it still doesn't charge, contact your local service provider.
C
Christina HullAug 23, 2025
What to do if LELY Ultrasonic Jewelry Cleaner shows 'CHARG TIMEOUT' error?
- U
  ualvarezAug 23, 2025
  If your LELY Ultrasonic Jewelry Cleaner displays 'CHARG TIMEOUT', indicating the battery isn't charging, try these steps: * Clean the charging strips and electrodes. * Manually guide the machine to the charging station. * Ensure the battery is charging. If the problem continues, contact your local service provider.
J
James WhiteAug 25, 2025
What to do if LELY Ultrasonic Jewelry Cleaner displays 'BATTVOLT LOW'?
- J
  Joseph RiveraAug 26, 2025
  If your LELY Ultrasonic Jewelry Cleaner displays 'BATTVOLT LOW', try the following steps: * Clean the charging strips and the charging electrodes. * Manually drive the machine to the charging station. * Make sure the battery is charging. If the problem remains, call your local service provider.
P
Patrick WheelerAug 27, 2025
How to resolve LELY Ultrasonic Jewelry Cleaner 'TURN BLOCK' error?
- K
  Kimberly VargasAug 27, 2025
  To address a 'TURN BLOCK' error on your LELY Ultrasonic Jewelry Cleaner, follow these steps: * Ensure there are no obstructions. * Inspect the sliding disc and replace it if it's worn. * Check the manure scraper and replace it if necessary.
P
Patricia PalmerAug 27, 2025
What to do if LELY Ultrasonic Jewelry Cleaner shows 'BLOCKAGE_DISC'?
- A
  awillisAug 28, 2025
  If your LELY Ultrasonic Jewelry Cleaner displays 'BLOCKAGE_DISC', follow these steps: * Ensure there are no obstacles. * Try running the route again. If the machine is blocked on the same place: * Do a route analysis. * Modify the routes that are unreliable. If the machine is blocked at a different place, calibrate the gyroscope.
C
Charles DaviesAug 29, 2025
How to fix 'CLOCK ERROR' on LELY Ultrasonic Jewelry Cleaner?
- K
  Kimberly ReevesAug 29, 2025
  To fix the 'CLOCK ERROR' on your LELY Ultrasonic Jewelry Cleaner, follow these steps: * Ensure the real-time clock is set in the correct 24-hour format. * Verify that all start and end times in the time path are entered in the correct 24-hour format. * Correct the clock or the start and end times if necessary.
G
Gregory SchwartzSep 14, 2025
What to do if LELY DISCOVERY 90 S Discovery says battery power too low to start route and suggests to clean charge strips?
- S
  Sandra DavisSep 14, 2025
  If the LELY Vacuum Cleaner Discovery's battery power is too low to start a route, clean the charging strips and the charging electrodes and charge the Discovery.
J
James BarnettSep 9, 2025
Why does my LELY DISCOVERY 90 S Vacuum Cleaner Discovery deviate from the correct direction?
- A
  Alyssa WrightSep 9, 2025
  If the LELY Vacuum Cleaner Discovery deviates from the correct direction, it may be because the vehicle did not reach the programmed position while turning, even after retrying. To address this, ensure there are no obstacles, calibrate the gyroscope, test the ultrasonic sensor and motors, and put the Discovery into operation. If the problem persists, perform a route analysis and modify any unreliable routes. If the problem still remains, contact your local service provider.
C
Christina SmithSep 6, 2025
Why does my LELY Vacuum Cleaner Discovery battery run down?
- S
  Steven DavisSep 6, 2025
  If the LELY Vacuum Cleaner Discovery's battery runs down, it could be due to not being charged or started on a route for more than 24 hours, or because the Discovery stops and beeps for 1 hour. To resolve this, clean the charging strips and electrodes, ensure the battery is charging, and charge the Discovery.
J
Julia ThompsonSep 3, 2025
How to fix 'ROUTE-MEMORY' full error on LELY Ultrasonic Jewelry Cleaner?
- B
  Barry ProctorSep 3, 2025
  To address the 'ROUTE-MEMORY' error on your LELY Ultrasonic Jewelry Cleaner, delete a route before programming a new one.