5.4002.8501.0 B
Operating Instructions 5-3
3. Remove the carabiner hook (1) (see figure 18 on page 5-3).
Figure 18. Remove or install the cover
KEY: 1. Carabiner hook - 2. Fastener - 3. Lower cover - 4. Upper cover
4. Pull the fastener on the rear (2) towards you.
5. Rotate the upper cover (4) towards the front side of the machine to remove the cover.
6. Only if necessary, remove the lower cover from the vehicle (3).
5.4.2 Install the Cover
1. Install the lower cover (3) (see figure 18 on page 5-3).
2. Put the bracket of the upper cover in the slot at the front side of the machine.
3. Lower the upper cover (4) at the rear side.
4. Close the fastener on the rear (2).
5. Install the carabiner hook (1) on the fastener (2).
in n o vato rs in ag ricu ltu r e
To Next Page
Loading...