LELY DISCOVERY 90 S - Replace the Sliding Disc

5.4002.8501.0 B
6-10 Maintenance
During the calibration process you must not move the machine.
Close-up
1. Use a suitable lifting or tilting tool to put the machine back onto its wheels.
2. Switch ON the Machine (see page 5-4).
3. Start the Lely Control Application (see page 5-5).
4. Push
.
During the calibration process you must not move the machine.
5. Push
Yes to start the gyroscope calibration process.
6. Wait until a beep is heard (about 5 minutes) to confirm that the calibration is complete.
7. Drive the Machine to the Charging Station (see page 5-7).
8. Start the time path to put the machine into operation (see Start or Stop the Time Path on page 5-33).
6.3.7 Replace the Sliding Disc
Preparation
1. Manually drive the machine to a clean and quiet location (see Manually drive the Machine on page 5-7).
2. Switch OFF the Machine (see page 5-4).
Replace
Unexpected cow movement.
Risk of being crushed or trampled.
Block the cow traffic.
in n o vato rs in ag ricu ltu r e