5.4002.8501.0 B
4-8 Description and Operation
• Settings are saved.
• The calibration of the gyroscope is finished.
• Backup is finished (create / restore).
• Programming a route.
4.2.2 Charging Station
The machine normally starts and ends at the charging station. The machine recharges itself at the
charging station. The battery charger electrodes are at the front near the bottom of the charging station.
The machine can be left permanently connected to the charging station. This keeps the battery in good
condition. The ADS3840 PCB continuously examines the voltage of the battery. It is not possible to
overcharge the battery.
The charging station has a 20 A electronic battery charger.
The charging station can be installed in the barn on the wall. If there is no wall at the desired charging
location, an optional floor column can be installed.
Battery Charger (Blue)
The 20 A electronic battery charger has two indicator LEDs on the upper right side. The LEDs are visible
through the opening in the red cover. The meaning of the LEDs are:
Status
Charging LED (orange) Power LED (green)
Mains connected
OFF ON
Recharging ( >1A)
ON ON
Battery Charger (Grey)
The 20 A electronic battery charger has two indicator LEDs on the upper right side. The LEDs are visible
through the opening in the red cover. The meaning of the LEDs are:
Status
Charging LED (orange) Power LED (green)
Mains connected
OFF ON
Recharging ( >1A)
ON ON
Error
blinking blinking
4.3 User Interface
The machine is operated with a smartphone with an Android or iOS operating system. The smartphone
communicates with the software via bluetooth. The main menu on the smart phone has the following
items:
• Work
• Routes
• Test
• Settings
• Alarms
in n o vato rs in ag ricu ltu r e
To Next Page
Loading...