5.4002.8501.0 B
Operating Instructions 5-25
Figure 36. Avoid angled bumping
5.11.1.3 Turn Left or Right
1. If you want to turn left, select Turn L <– and push
.
2. If you want to turn left, select Turn R –> and push
.
3. Read the message on the display and push
.
You can choose from 12 standard turns (see Turn Right or Left on page 4-15) and modify
the turn afterwards. Preferably do not make sharp turns in heavy polluted areas (less
power).
4. Push
until the most appropriate standard turn is displayed, or push to go to the pervious
display.
5. Select one of the standard turns with the appropriate soft button (see Turn Right or Left on page 4-
15).
6. If you want to modify the turn angle, push
or to select the angle.
in n o vato rs in ag ricu ltu r e
To Next Page
Loading...