Description of components
Chapter 3 - page 4
3
D-H002.0607EN
3.4 E-link manual controller
You can use the E-link manual control (figure 3 6) to operate and programme the barn cleaner.
The E-link manual controller consists of an LCD display with
9 function buttons. The following buttons are used for
operating the barn cleaner:
(1) - Next screen/ENTER
This button is used to open the selected menu and call up the
next menu screen. Data is input or changed via the screen
currently displayed.
(2) - Previous screen/ESC
Use this key to select the previous screen of the current
menu.
(3) - Display
(4) - UP button +
Depending on the screen currently displayed, this key is used
to select an option, modify a value or confirm a command.
(5) - DOWN button ā
See description of previous button
(6) - Start/Stop button
There are a limited number of cases where a procedure can
be stopped or started using this button.
(7) - PR button
Is used to reduce the speed when programming the barn
cleaner, in particular when approaching a collision point
(reference point).
(8) - Buttons Soft1 to Soft3 (from left to right)
3
2
5
4
6
1
7
8
Figure 3 6 E-link manual controller
To Next Page
Loading...
