LEMKEN Opal 080 E - Turnover Device

63 pages

Save Page as PDF

To Next Page

To Previous Page

Layout and description

5.2.5 Turnover device

The ploughs of the Opal 080 series feature the hydraulic turnover device D60.

Main Page

Table of Contents5
Allgemeines9
Copyright9
Optional Accessories9
Symbols Used in the Operating Instructions10
Hazard Classes10
Information10
Environmental Protection10
Indication of Passages11
Safety Measures and Precautions12
Target Group12
Intended Use12
Safety Features of the Device13
Safety and Warning Signs13
General Information13
Position of Warning Stickers14
Meaning of Warning Signs15
Special Safety Instructions16
Danger Areas During Implement Operation18
Residual Risks19
Hazard Caused by Mechanical Systems19
Hazard Caused by Hydraulic Systems19
Applicable Rules and Regulations19
Operation on Public Highways20
Lighting System and Identification20
Requirements of the Tractor20
Axle Loads21
Check before Departure24
Correct Behaviour in Road Traffic25
Obligation of the Operator25
Safe Use of the Implement26
General26
Personnel Selection and Qualifications27
Hydraulic System28
Handing over the Implement29
Layout and Description30
Overview30
Description31
Headstock31
Stand31
Plough Bodies31
Basic Frame31
Turnover Device32
Preparations on Tractor33
Tyres33
Lifting Rods33
Top Link33
Chains and Stabilisers of the Three-Way Linkage33
Hydraulics33
Hydraulic Equipment Required34
Preparing the Implement35
General35
Upper Control Link Length35
Three-Point Connection35
Attaching the Implement37
Specific Safety Information37
General37
Uncoupling the Implement39
Specific Safety Information39
General39
Driving on Public Roads42
Laws and Regulations42
Operation43
Specific Safety Information43
Turning the Plough Frame43
Adjusting Front Furrow Width44
General Information44
Front Furrow Width44
Angle45
General Information45
Angular Adjustment (Double Acting)45
Working Depth46
DURAL Plough Body46
Angle46
Working Width for each Body47
Tail Pieces47
Sword Coulter48
Shearing Protection48
Put the Implement out of Operation51
Shutting down the Implement in an Emergency51
Disposal51
Maintenance and Repairs52
Special Safety Instructions52
General52
Working under the Raised Device52
Immobilise the Implement for Maintenance and Repairs53
Working on the Hydraulics53
Personnel Qualifications53
Protective Equipment54
Utilised Tool54
Environmental Protection55
Maintenance Intervals55
After Initial Commissioning (after no more than 2 Hours)55
Daily Checks55
Weekly Checks56
Tightening Torques56
General56
Bolts and Nuts Made of Steel57
Check the Connections to the Tractor57
Hydraulic Connections57
Lubrication Schedule58
Troubleshooting59
Plough Penetration and Depth Control, Slippage59
Miscellaneous60
Technical Data61
Permissible Power Range and Weight61
Type Plate61
Index63

LEMKEN Opal 080 E - Turnover Device

Table of Contents

Related product manuals