The TV set incorporates multiple video modes, you can select the video mode according to the input
signal.
Press the INPUT button on the remote control or the SOURCE button on the right side panel of the
TV repeatedly, and you can select the video mode in the following order:
TV => SCART => Composite => S-Video => YPbPr => VGA => HDMI =>
DVD
If you remove the removable DVD module and press the INPUT button on the remote control or the
SOURCE button on the right side panel of the TV repeatedly, then you can select the video mode in
the following order:
TV => SCART => Composite => S-Video => YPbPr => VGA => HDMI
NOTE:
If there is no signal provided in VGA mode, the unit will enter the standby mode 1 minute
later and it will enter work state once there is a VGA signal provided.
In other modes, if there is no signal provided the unit will enter power-off mode 15
minutes later. You can restart the TV by pressing the POWER button.
To Next Page
Loading...
