LENCO Pro Control - Pro Control Faults; Things to Consider When Troubleshooting

22
lencomarine.com
Faults
Pro Control Faults
Fault Indicator –
actuators, true of auto
or assist
Status Cause Resolution
Right, and/or left hand,
LEDs flashing fast
Port, or starboard,
actuator is not
responding
One or both, actuators
not extending per drive
command
Keypad not
communicating
with port or
starboard actuator
Faulty actuator
Recommission Pro
Control system
Navico Group™ service
Medium flash for all left,
or right hand, LEDs
Actuator still moves
but will not move to
a position command,
only moved by jogs,
while all LEDs are
flashing
Faulty actuator Navico Group™ service
Periodic flash, shows %
position but every ten
seconds all left side, or
right side, LEDs flash
The port actuator had
a temporary fault that
reset
n/a Actuator faults will
self clear
If a fault continues to
display, then the fault
condition is still present
Both FAV LEDs
flash twice
n/a No FAV 1 or FAV 2
stored
Save FAV trim tab
position
FAV 1 and FAV 2 will not
light up, or turns o if
lit without touching any
other buttons and will
not turn back on
Will also show fault blink
on LEDs
A critical, or a
non-critical, fault in an
actuator has occurred
Faulty actuator Navico Group™ service
AUTO, or HOLD, button
led will double flash
n/a IMU not
communicating
Boat not on plane
Navico Group™ service
Secure all NMEA®
cabling connections
Recalibration Pro
Control Auto system
Both Auto & Hold, or
both FAVs, double flash
when trying to enter
locating mode
SOG higher than
6 mph
SOG higher than
6 mph
Slow boat speed to less
than 6 mph
Things to Consider When Troubleshooting
1. Make sure you check all connections and wiring for corrosion, as this can cause
unforeseen problems
2. Make sure you have a fully charged battery and terminals are free of corrosion
For More information on additional troubleshooting, or any of the Lenco Marine products
please visit our website: lencomarine.com