Figure 93. Lenovo XClarity Controller network access label on the pull-out information tab
After this task is completed
1. Proceed to install the other components of the system-board assembly.
• Install a bridge board (see “Install a bridge board” on page 112).
• Install an I/O module board (see
“Install an I/O module board” on page 114).
• Install a front I/O bezel (see
“Install a front I/O bezel” on page 116).
2. Reinstall any components that have been removed from the system board and connect all required
cables
(see related topics in
Chapter 1 “Hardware replacement procedures” on page 1 and Chapter 2 “Internal
cable routing” on page 127
), such as the following.
a. Reinstall the power input board module and the power main board and connect the required cables
between these two components (see
“Install a power input board module” on page 84, “Install a
power module board” on page 87
, and “Cable routing for the power module board and power input
board module” on page 136
).
b. Reinstall all the required memory modules (see “Install a memory module” on page 75).
c. If applicable, reinstall the intrusion switch with cable and connect the cable to the system board(see
“Install an intrusion switch with cable” on page 62).
d. Reinstall the front operator assembly and connect the cable to the system board (see
“Install a front
operator assembly” on page 59
).
e. Reinstall the MicroSD card (see
“Install a MicroSD card” on page 80).
f. Reinstall the keylock switch with cable and connect the cable to the system board (see
“Install a
keylock switch with cable” on page 66
).
g. Reinstall the drive cage and connect the required cables to the system board and the I/O module
board (see
“Install a drive cage” on page 50and “Cable routing for the hot-swap drives” on page
129
).
h. Connect and route all the required cables into place (see
Chapter 2 “Internal cable routing” on page
127
).
3. Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 125).
4. Reconfigure the server and reset the system date and time.
5. Update the machine type and serial number with the new vital product data (VPD) using the Lenovo
XClarity Provisioning Manager (see
“Update the Vital Product Data (VPD)” on page 117).
Chapter 1. Hardware replacement procedures 111
To Next Page
Loading...
