If your server is installed in a rack, you can use the rack latches to help you slide the server out of the rack.
You also can use the rack latches and screws to secure the server in the rack so that the server cannot slide
out, especially in vibration-prone areas. For more information, refer to the Rack Installation Guide that comes
with your rail kit.
2 3.5-inch simple-swap drive bays
The number of the installed drives in your server varies by model. When you install drives, follow the order of
the drive bay numbers.
The EMI integrity and cooling of the server are protected by having all drive bays occupied. The vacant drive
bays must be occupied by drive fillers.
3 Front I/O assembly
For information about the controls, connectors, and status LEDs on the front I/O assembly, see “Front I/O
assembly” on page 19.
5 Pull-out information tab
The Lenovo XClarity Controller network access label of the server is attached on the pull-out information tab.
6 VGA connector (optional)
Used to attach a high-performance monitor, a direct-drive monitor, or other devices that use a VGA
connector.
Front I/O assembly
The front I/O assembly of the server provides controls, connectors, and LEDs. The front I/O assembly varies
by model.
The following illustrations show two types of front I/O assembly.
Figure 9. Front I/O assembly for server models with 2.5-inch-drive bays or eight 3.5-inch-drive bays
Chapter 2. Server components 19
To Next Page
Loading...
