Lenovo ThinkSystem SR550 - Install a Simple-Swap Drive

To install a hot-swap drive, complete the following steps:
Watch the procedure. A video of the installation process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C9jFjZnXQ6AmTXaIdX6_HJ
• Youku: http://list.youku.com/albumlist/show/id_50429987
Figure 58. 2.5-inch hot-swap drive installation
Figure 59. 3.5-inch hot-swap drive installation
Step 1. Ensure that the drive handle is in the open position. Slide the drive into the drive bay until it snaps
into position.
Step 2. Rotate the tray handle to the closed position.
Install a simple-swap drive
Use this information to install a simple-swap drive.
Chapter 3. Server hardware setup 87