Figure 29. Top cover removal
Step 1. Use a screwdriver to turn the cover lock to the open position as shown.
Step 2. Press the release button on the cover latch and fully open the cover latch.
Step 3. Slide the top cover to the rear until it is disengaged from the chassis. Then, lift the top cover off the
chassis and place the top cover on a flat clean surface.
Remove the air baffle
Use this information to remove the air baffle.
“Read the
installation
Guidelines” on
page 46
“Power off
the server
for this task”
on page 90
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 48
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
S017
52
ThinkSystem SR550 Setup Guide
To Next Page
Loading...
