Lenovo ThinkSystem SR550 - Install a RAID Super Capacitor Module

Note: Close the retaining clip on each end of the DIMM slot before installing the air baffle for
proper cooling.
Step 3. Install any RAID super capacitor module that you have removed.
After installing the air baffle, install the top cover. See “Install the top cover” on page 84.
Install a RAID super capacitor module
Use this information to install a RAID super capacitor module.
“Read the
installation
Guidelines” on
page 46
“Power off
the server
for this task”
on page 90
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 48
Before installing a RAID super capacitor module, touch the static-protective package that contains the new
RAID super capacitor module to any unpainted surface on the outside of the server. Then, take the new RAID
super capacitor module out of the package and place it on a static-protective surface.
To install a RAID super capacitor module, complete the following steps:
Watch the procedure. A video of the installation process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C9jFjZnXQ6AmTXaIdX6_HJ
• Youku: http://list.youku.com/albumlist/show/id_50429987
Step 1. Note the orientation of the RAID super capacitor module. Then, gently press the tab on the air baffle
as shown and install the RAID super capacitor module onto the air baffle at the same time.
Figure 53. RAID super capacitor module installation
Step 2. Connect the RAID super capacitor module to the RAID adapter using an extension cable.
Chapter 3. Server hardware setup 83