Server models with twelve 3.5-inch hot-swap drives
Use this section to understand the cable routing for server models with twelve 3.5-inch hot-swap drives.
Figure 18. Cable routing for server models with twelve 3.5-inch hot-swap drives and 16i adapter
Cable From To
1 SAS signal cable SAS 0 and SAS 1 connectors on the
backplane
C0 and C1 connectors on the RAID
adapter installed in PCIe slot 4
2 SAS signal cable SAS 2 connector on the backplane C2 connector on the RAID adapter
installed in PCIe slot 4
3 Power cable Power connector 1 on the backplane Backplane power connector 1 on the
system board
4 Power cable Power connector 2 on the backplane Backplane power connector 2 on the
system board
Chapter 2. Server components 33
To Next Page
Loading...
