Lenovo ThinkSystem SR550 - Install the LOM Adapter

• For Linux operating system:
Open the ipmitool and enter the following command to disable the Serial over LAN (SOL) feature:
-I lanplus -H IP -U USERID -P PASSW0RD sol deactivate
• For Microsoft Windows operating system:
1. Open the ipmitool and enter the following command to disable the SOL feature:
-I lanplus -H IP -U USERID -P PASSW0RD sol deactivate
2. Open Windows PowerShell and enter the following command to disable the Emergency Management
Services (EMS) feature:
Bcdedit /ems no
3. Restart the server to ensure that the EMS setting takes effect.
Install the LOM adapter
Use this information to install the LOM adapter.
“Read the
installation
Guidelines” on
page 46
“Power off
the server
for this task”
on page 90
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 48
Before installing the LOM adapter:
• If the server comes with a LOM adapter slot bracket, remove it with a tool first. Store the bracket in case
that you later remove the LOM adapter and need the bracket to cover the place.
CAUTION:
Use a tool to remove the LOM adapter slot bracket to avoid injury.
• Touch the static-protective package that contains the new LOM adapter to any unpainted surface on the
outside of the server. Then, take the new LOM adapter out of the package and place it on a static-
protective surface.
To install the LOM adapter, complete the following steps:
Watch the procedure. A video of the installation process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C9jFjZnXQ6AmTXaIdX6_HJ
• Youku: http://list.youku.com/albumlist/show/id_50429987
Chapter 3. Server hardware setup 69