Server models with eight 2.5-inch hot-swap drives
Use this section to understand the cable routing for server models with eight 2.5-inch hot-swap drives.
Note: Both 8i and 16i RAID adapters are supported in this configuration. 
Figure 20. Cable routing for server models with eight 2.5-inch hot-swap drives
Cable
From To
1  SAS signal cable SAS 0 and SAS 1 connectors on the 
backplane
C0 and C1 connectors on the RAID 
adapter installed in PCIe slot 4
2  Power cable Power connector on the backplane Backplane power connector 1 on the 
system board
Chapter 2. Server components 35