• You can mix drives of different types and different capacities in one system, but not in one RAID array.
The following order is recommended when installing the drives:
– Drive type priority: SAS SSD, SATA SSD, SAS HDD, SATA HDD
– Drive capacity priority: the lowest capacity first
• The drives in a single RAID array must be the same type, same size, and with the same capacity.
Before installing a hot-swap drive:
1. If there is a drive filler installed, remove it and keep it in a safe place.
Figure 56. 2.5-inch drive filler removal
Figure 57. 3.5-inch drive filler removal
2. Touch the static-protective package that contains the new drive to any unpainted surface on the outside
of the server. Then, take the new drive out of the package.
86
ThinkSystem SR550 Setup Guide
To Next Page
Loading...
