“Read the
installation
Guidelines” on
page 46
“Power off
the server
for this task”
on page 90
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 48
Notes: Your server supports up to two 2.5-inch SATA/SAS 8-bay backplanes. Depending on the backplane
quantity, the installation location of the backplanes varies.
• One backplane: Always install the backplane to drive bays 0–7.
• Two backplanes: Install the two backplanes to drive bays 0–7 and drive bays 8–15.
Before installing the 2.5-inch-drive backplane, touch the static-protective package that contains the new
backplane to any unpainted surface on the outside of the server. Then, take the new backplane out of the
package and place it on a static-protective surface.
To install the 2.5-inch-drive backplane, complete the following steps:
Watch the procedure. A video of the installation process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C9jFjZnXQ6AmTXaIdX6_HJ
• Youku: http://list.youku.com/albumlist/show/id_50429987
Step 1. Determine the location of the backplanes to be installed.
Step 2. Connect the cables to the backplane.
62
ThinkSystem SR550 Setup Guide
To Next Page
Loading...
