Server model: twelve 3.5-inch SAS/SATA drives, the rear hot-swap drive assembly, one 8i RAID
adapter, one 16i RAID adapter
Note: The cable routing illustration is based on the scenario that the rear hot-swap drive assembly is
installed. Depending on the model, the rear hot-swap drive assembly and the 8i RAID adapter might not be
available on your server.
Figure 68. Cable routing for server models with twelve 3.5-inch SAS/SATA drives, the rear hot-swap drive assembly, one
8i RAID adapter, and one 16i RAID adapter
Cable
From To
1 Power cable Power 1 connector on the front
backplane
Backplane power connector 1 on the
system board
2 SAS signal cable SAS 0, SAS 1, and SAS 2 connectors
on the backplane
C0, C1, and C2 connectors on the 16i
RAID adapter installed on the RAID
adapter slot
Chapter 2. Server components 117
To Next Page
Loading...
