“Read the
installation
Guidelines” on
page 126
“Power off
the server for
this task” on
page 194
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 127
Before installing the LOM adapter:
1. If the server comes with a LOM adapter slot bracket, remove it with a tool first. Store the bracket in case
that you later remove the LOM adapter and need the bracket to cover the place.
CAUTION:
Use a tool to remove the LOM adapter slot bracket to avoid injury.
2. Lift the LOM-adapter air baffle out of the chassis.
3. Touch the static-protective package that contains the new LOM adapter to any unpainted surface on the
outside of the server. Then, take the new LOM adapter out of the package and place it on a static-
protective surface.
To install the LOM adapter, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku: http://list.youku.com/albumlist/show/id_50483444
Figure 104. LOM adapter installation
Step 1. Place the LOM adapter into the connector at an angle.
Step 2. Rotate the LOM adapter down.
Step 3. Push the LOM adapter as shown to insert it into the connector on the system board.
Step 4. Tighten the thumbscrew to secure the LOM adapter.
Step 5. Align the mounting stud on the chassis with the hole in the LOM-adapter air baffle. Then, pinch the
tab
1 and lower the LOM-adapter air baffle onto the LOM adapter.
Install the serial port module
Use this information to install the serial port module.
“Read the
installation
Guidelines” on
page 126
“Power off
the server for
this task” on
page 194
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 127
Chapter 3. Server hardware setup 175
To Next Page
Loading...
