Lenovo ThinkSystem SR650 Series - Install a hot-swap power supply

Install the system fan cage
Use this information to install the system fan cage.
“Read the
installation
Guidelines” on
page 126
“Power off
the server for
this task” on
page 194
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 127
To install the system fan cage, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku: http://list.youku.com/albumlist/show/id_50483444
Figure 106. System fan cage installation
Step 1. Align both sides of the system fan cage with the corresponding mounting posts in the chassis.
Then, press the system fan cage straight down into the chassis.
Step 2. Rotate the levers of the system fan cage to the front of the server to secure the system fan cage.
Install a system fan
Use this information to install a system fan.
“Read the
installation
Guidelines” on
page 126
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 127
Chapter 3. Server hardware setup 177