Server model: four 2.5-inch SAS/SATA drives, four 2.5-inch SAS/SATA/NVMe drives, the rear hot-swap
drive assembly, one 24i RAID adapter
Note: The cable routing illustration is based on the scenario that the rear hot-swap drive assembly is
installed. Depending on the model, the rear hot-swap drive assembly and the cable
4 might not be available
on your server.
Figure 28. Cable routing for server models with four 2.5-inch SAS/SATA drives, four 2.5-inch SAS/SATA/NVMe drives,
the rear hot-swap drive assembly, and one 24i RAID adapter
Cable
From To
1 Power cable for front backplane Power connector on front backplane Backplane power connector 1 on the
system board
2 SAS signal cable for front
backplane
SAS 0 and SAS 1 connectors on front
backplane
C0 and C1 connectors on the 24i
RAID adapter installed in PCIe slot 5
3 NVMe signal cable for front
backplane
NVMe 0, NVMe 1, NVMe 2, and
NVMe 3 connectors on front
backplane
NVMe 0–1 and NVMe 2–3 connectors
on the system board
4 SAS signal cable for the rear hot-
swap drive assembly
Signal connector on the rear hot-
swap drive assembly
C2 connector on the 24i RAID
adapter installed in PCIe slot 5
Chapter 2. Server components 51
To Next Page
Loading...
