Figure 112. Installation of the large-size air baffle
After installing the air baffle, install any RAID super capacitor modules that you removed.
Install the RAID super capacitor module
Use this information to install the RAID super capacitor module.
“Read the
installation
Guidelines” on
page 126
“Power off
the server for
this task” on
page 194
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 127
Before installing a RAID super capacitor module:
1. Touch the static-protective package that contains the new RAID super capacitor module to any
unpainted surface on the outside of the server. Then, take the new RAID super capacitor module out of
the package and place it on a static-protective surface.
2. Locate the holder for the RAID super capacitor module on the air baffle and note the orientation of the
RAID super capacitor module.
To install a RAID super capacitor module, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku: http://list.youku.com/albumlist/show/id_50483444
188 ThinkSystem SR650 Setup Guide
To Next Page
Loading...
