Figure 74. Top cover removal
Step 1. Use a screwdriver to turn the cover lock to the unlocked position as shown.
Step 2. Press the release button on the cover latch and then fully open the cover latch.
Step 3. Slide the top cover to the rear until it is disengaged from the chassis. Then, lift the top cover off the
chassis and place the top cover on a flat clean surface.
Attention:
• Handle the top cover carefully. Dropping the top cover with the cover latch open might damage
the cover latch.
• For proper cooling and airflow, install the top cover before you turn on the server. Operating the
server with the top cover removed might damage server components.
Remove the air baffle
If you intend to install hardware options in the server, you must first remove the air baffle from the server.
“Read the
installation
Guidelines” on
page 126
“Power off the
server for this
task” on page
194
S033
Chapter 3. Server hardware setup 131
To Next Page
Loading...
