Server models with eight 2.5-inch drives
Use this section to understand the cable routing for server models with eight 2.5-inch drives.
Server model: eight 2.5-inch SAS/SATA drives, the rear hot-swap drive assembly, one 16i RAID
adapter
Note: The cable routing illustration is based on the scenario that the rear hot-swap drive assembly is
installed. Depending on the model, the rear hot-swap drive assembly and the cable
3 might not be available
on your server.
Figure 21. Cable routing for server models with eight 2.5-inch SAS/SATA drives, the rear hot-swap drive assembly, and
one 16i RAID adapter
42 ThinkSystem SR650 Setup Guide
To Next Page
Loading...
