Server model: eight 2.5-inch SAS/SATA drives, the rear hot-swap drive assembly, one 24i RAID
adapter
Note: The cable routing illustration is based on the scenario that the rear hot-swap drive assembly is
installed. Depending on the model, the rear hot-swap drive assembly and the cable
3 might not be available
on your server.
Figure 22. Cable routing for server models with eight 2.5-inch SAS/SATA drives, the rear hot-swap drive assembly, and
one 24i RAID adapter
Cable
From To
1 Power cable for front backplane Power connector on front backplane Backplane power connector 1 on the
system board
2 SAS signal cable for front
backplane
SAS 0 and SAS 1 connectors on front
backplane
C0 and C1 connectors on the 24i
RAID adapter
3 SAS signal cable for the rear hot-
swap drive assembly
Signal connector on the rear hot-
swap drive assembly
C2 connector on the 24i RAID
adapter
44 ThinkSystem SR650 Setup Guide
To Next Page
Loading...
