Figure 71. A1 rearwall bracket installation
a. Align the pin on the rearwall bracket and the pin slot on the left side of the rear chassis. Install
the bracket to the chassis as shown.
b. Install the three screws to secure the rearwall bracket.
After you finish
Install a rear drive cage or riser assemblies. See
• “Install the 4 x 2.5-inch rear drive cage” on page 191
• “Install the 8 x 2.5-inch rear drive cage” on page 193
• “Install the 2 x 3.5-inch rear drive cage” on page 188
• “Install the 4 x 3.5-inch rear drive cage” on page 189
• “Install a riser 1/2 assembly” on page 204
Install a B1/B2 rearwall bracket (middle)
Use this information to install a B1/B2 rearwall on the middle of the rear chassis.
About this task
Attention:
• Read “Installation Guidelines” on page 134 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Bz2XIeLEfGcrLGm9TSY_yt
• Youku: http://list.youku.com/albumlist/show/id_52339612.html
Procedure
Chapter 4. Server hardware setup 181
To Next Page
Loading...
