Procedure
Step 1. Locate the correct keyhole that the retainer should be installed into to accommodate the particular
size of the M.2 drive you wish to install.
Step 2. Adjust the M.2 retainer.
Figure 89. M.2 retainer adjustment
a. Press both sides of the retainer.
b. Move the retainer forward until it is in the large opening of the keyhole.
c. Take the retainer out of the keyhole.
d. Insert the retainer into the correct keyhole.
e. Press both sides of the retainer.
f. Slide the retainer backwards (toward the small opening of the keyhole) until it is seated in
place.
Install a riser 1/2 assembly
Use this information to install a riser 1 assembly or riser 2 assembly.
About this task
Attention:
• Read “Installation Guidelines” on page 134 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Bz2XIeLEfGcrLGm9TSY_yt
• Youku: http://list.youku.com/albumlist/show/id_52339612.html
Procedure
204 ThinkSystem SR665 Setup Guide
To Next Page
Loading...
