• For a single-wide GPU adapter (for example, NVIDIA T4 GPU), install the add-on air baffle onto
the GPU air baffle.
Figure 98. Installing the add-on air baffle for a single-wide GPU adapter
Step 2. Locate the appropriate PCIe slot for the GPU adapter.
Step 3. Align the GPU adapter with the PCIe slot on the riser card. Then, carefully press the GPU adapter
straight into the slot until it is securely seated.
Step 4. Connect the power cable to the power connector on the GPU.
Step 5. Install the riser assembly. See
Install the OCP 3.0 Ethernet adapter
Use this information to install the OCP 3.0 Ethernet adapter.
About this task
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Attention:
• Read “Installation Guidelines” on page 134 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Bz2XIeLEfGcrLGm9TSY_yt
212 ThinkSystem SR665 Setup Guide
To Next Page
Loading...
