Step 5. Install a riser 3 assembly.
Figure 95. Riser 3 assembly installation
a. Align the securing clip at the end of the riser cage with the pin on the rear chassis, the pin on
the right side of the riser cage with the pin slot on the C1 rearwall bracket. Carefully put down
the riser 3 assembly until it is securely seated.
After you finish
1. Refer to Chapter 3 “Internal cable routing” on page 61 to connect any cables to the PCIe adapters.
Install the internal CFF RAID/HBA/RAID expander adapter
Use this information to install the internal CFF RAID/HBA/RAID expander adapter.
About this task
Attention:
• Read “Installation Guidelines” on page 134 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Bz2XIeLEfGcrLGm9TSY_yt
• Youku: http://list.youku.com/albumlist/show/id_52339612.html
Procedure
Chapter 4. Server hardware setup 209
To Next Page
Loading...
