• Youku: http://list.youku.com/albumlist/show/id_52339612.html
Procedure
Step 1. Touch the static-protective package that contains the new backplane to any unpainted surface on
the outside of the server. Then, take the new backplane out of the package and place it on a static-
protective surface.
Step 2. Install the two 7mm backplanes. See “Install the 7mm drive backplanes” on page 175.
Step 3. Connect the cables to the backplanes. See “7mm drives” on page 68.
Chapter 4. Server hardware setup 195
To Next Page
Loading...
