Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with one
of these parts, contact a service technician.
Before removing a hot-swap power supply unit:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 59).
To remove a hot-swap power supply unit, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/watch?v=pIb0bIyfkDY&=PLYV5R7hVcs-Ak9fT8QAx8fLbEivizjRtp
• Youku: http://v.youku.com/v_show/id_XMzMyODU3NTY2NA==.html?spm=a2hzp.8253876.0.0&f=51276390
Step 1. Press and hold on the orange release tab.
Figure 105. Power supply unit removal
Step 2. Grasp the handle, pull the power supply out of the server.
Note: Fill the power supply bay with a filler if you are not replacing a new power supply
immediately.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a hot-swap power supply unit
Use this procedure to install a hot-swap power supply unit.
S002
108
ThinkSystem SR860 Maintenance Manual
To Next Page
Loading...
