Lenovo ThinkSystem SR860 - System Board Air Baffle and the Power Interposer Replacement

Figure 123. Security bezel installation
1 Release latch
Step 2. Use the key to lock the security bezel to the closed position.
Figure 124. Locking the security bezel
After installing the security bezel, push or install the server into the rack if necessary. See ThinkSystem
SR860 Rack Installation Guide that comes with the rail kit.
System board air baffle and the power interposer replacement
Use this procedure to install or remove the system board air baffle and the power interposer.
Note: If your server comes with four processors, skip this section and go to “Processor and memory
expansion tray replacement” on page 121.
Remove the system board air baffle and the power interposer
Use this procedure to remove the system board air baffle and the power interposer.
Note: If the server comes with a processor and memory expansion tray, it does not come with this
component.
Before removing the system board air baffle, complete the following steps:
128
ThinkSystem SR860 Maintenance Manual