Figure 145. 4U PCIe riser assembly installation
Table 54. Guide pin and assembly filler
1 Guide pin 2 4U PCIe riser assembly filler
After installing a 4U PCIe riser assembly, complete the following steps:
1. Install the top cover (see “Install the top cover” on page 148).
2. If the server is installed in a rack, reinstall the server into the rack.
3. Power on the server and any peripheral devices.
4U PCIe riser card replacement
Use this procedure to install or remove a 4U PCIe riser card.
Remove a 4U PCIe riser card
Use this procedure to remove a 4U PCIe riser card.
Before removing a 4U PCIe riser card:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 59).
Chapter 3. Hardware replacement procedures 155
To Next Page
Loading...
