CAUTION:
Never remove the cover on a power supply or any part that has this label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with one
of these parts, contact a service technician.
Following are the types of power supply units compatible to this server and notices to take during
installation. These power supplies are designed for parallel operation. In the event of a power-supply failure,
the redundant power supply continues to power the system. The server supports a maximum of two power
supplies with N+1 redundancy support.
• 750-watt platinum power supply
– input power 115V or 230V ac
• 1100-watt platinum power supply
– input power 115V or 230V ac
• 1600-watt platinum power supply
– input power 230V ac
• 2000-watt platinum power supply
– input power 230V ac
Before installing a hot-swap power supply:
1. Read the safety information and installation guidelines (see “Safety” on page iii and “Installation
Guidelines” on page 59).
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
3. If the power supply unit to be installed comes with different wattage than the one that is already
installed, turn off the server and peripheral devices, and disconnect the power cords and all external
cables; then, remove the installed power supply unit (see “Remove a hot-swap power supply unit” on
page 106).
Important: Do not mix power supplies with different wattages in the same server.
To install a power supply unit, complete the following steps:
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/watch?v=pIb0bIyfkDY&=PLYV5R7hVcs-Ak9fT8QAx8fLbEivizjRtp
• Youku: http://v.youku.com/v_show/id_XMzMyODU3NTY2NA==.html?spm=a2hzp.8253876.0.0&f=51276390
Step 1. If you are installing the power supply into an empty bay, remove the power-supply filler panel from
the power-supply bay.
Step 2. Grasp the handle on the rear of the power supply, and slide it into the power-supply bay until it
clicks into place.
110
ThinkSystem SR860 Maintenance Manual
To Next Page
Loading...
