Figure 114. Processor locations
Table 51. Processor locations
1 Processor 3 3 Processor 1
2 Processor 4 4 Processor 2
Complete the following steps to install a PHM.
Watch the procedure. A video of the process is available:
• Youtube:
https://www.youtube.com/watch?v=pIb0bIyfkDY&=PLYV5R7hVcs-Ak9fT8QAx8fLbEivizjRtp
• Youku: http://v.youku.com/v_show/id_XMzMyODU3NTY2NA==.html?spm=a2hzp.8253876.0.0&f=51276390
Step 1. Remove the processor socket cover, if one is installed on the processor socket, by placing your
fingers in the half-circles at each end of the cover and lifting it from the system board.
Step 2. Install the processor-heat-sink module on the system board.
120
ThinkSystem SR860 Maintenance Manual
To Next Page
Loading...
